1、06H3C WX系列AC+Fit AP AP自动升级版本典型配置举例H3C WX系列AC+Fit AP AP自动升级版本典型配置举例关键词:AP, AC, LWAPP缩略语:缩略语英文全名中文解释APAcess Point无线接入点ACAccess Controler无线控制器LWAPPLight Weigthed AP Protocol轻量AP协议WLANWireless Local Network无线局域网1 特性简介AP版本自动升级功能,可以实现,人工升级AC后,AP检测到AC的版本已经更新,会自动从AC上获取最新的相应版本, 更新到最新版本。1.1 特性优点降低了管理AP的工作量。2
2、应用场合这个特性,当有大量AP需要升级版本或者AP布置在比较难于触及的地方时, 有极大的方便性。 3 注意事项Bootrom版本要能够兼容新的AP版本。4 AP自动升级版本的典型配置举例4.1 组网需求本配置举例中的AC使用的是WX5002无线控制器,AP使用的是WA2100无线局域网接入点。图4-1 AP自动升级版本的典型配置举例组网图4.2 配置思路需要配置以下内容: 版本升级前,AP和AC处于正常工作状态。 保存AC的配置,并设置默认启动配置;然后从版本服务获取最新的AC和AP的版本到AC上面来,AP的名称应符合要求,例如Fit AP WA2100的升级版本名称,必须为wa2100.bi
3、n。 重启AC之后,AP将会进行版本检测,自动升级版本;并重新恢复保存的配置。4.3 使用版本1. AC版本display versionH3C Comware Platform SoftwareComware Software, Version 5.00, ESS 1102P01Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.H3C WX5002-128 uptime is 0 week, 0 day, 0 hour, 3 minutes CPU type: BCM MIPS 1250 700M
4、Hz 1024M bytes DDR SDRAM Memory 32M bytes Flash Memory Pcb Version: A Logic Version: 1.0 Basic BootROM Version: 1.12 Extend BootROM Version: 1.13 SLOT 1CON (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1GE1/0/1 (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1GE1/0/2 (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1M-
5、E1/0/1 (Hardware)A, (Driver)1.0, (Cpld)1.02. AP版本_display versionH3C Comware Platform SoftwareComware Software, Version 5.00, ESS 1102P01Comware Platform Software Version COMWAREV500R002B35D004H3C WA2100 Software Version V100R001B05D004Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights
6、reserved.Compiled Jun 12 2007 15:52:46, RELEASE SOFTWAREH3C WA2100 uptime is 0 week, 0 day, 0 hour, 0 minute CPU type: ATHEROS MIPS 2313 180MHz 32M bytes SDRAM Memory 4M bytes Flash Memory Pcb Version: Ver.B Basic BootROM Version: 1.08 Extend BootROM Version: 1.08 SLOT 1CON (Hardware)Ver.B, (Driver)
7、1.0 SLOT 1RADIO1/0/1 (Hardware)Ver.B, (Driver)1.0 SLOT 1ETH1/0/1 (Hardware)Ver.B, (Driver)1.04.4 操作步骤1. 确认网络状况良好需要确认网络状况,AC和AP之间的网络能够通畅,保证AC和AP在没有升级版本时,能够成功连接。display wlan ap all Total Number of APs configured: 1 Total Number of APs connected : 1 AP Profiles- AP Name APID State Model Serial-ID- test
8、ap 1 Run WA2100 x028652 -display wlan ap all verbose Total Number of APs configured: 1 Total Number of APs connected : 1 AP Profile: testap - APID : 1 AP Name : testap State : Run Up Time(hh:mm:ss) : 00:00:27 Model : WA2100 Serial-ID : x028652 IP Address : 202.1.1.2 H/W Version : Ver.B S/W Version :
9、 V100R001B05D004 Boot-Rom Version : 1.08 Description : -NA- Echo Interval(s) : 10 Statistics report Interval(s) : 600 Cir(Kbps) : -NA- Cbs(Bytes) : -NA- Jumboframe Threshold : Disable Configuration Failure Count : -NA- Last Failure Reason : -NA- Last Reboot Reason : Tunnel Initiated - AP Mode : Spli
10、t Maximum Number of Radios : 1 Current Number of Radios : 1 Client Keep-alive Interval : Disable Client Idle Interval(s) : 3600 Broadcast-probe Reply Status : Enable Radio 1: Basic BSSID : 000f-e255-54f0 Current BSS Count : 2 Running Clients Count : 0 Wireless Mode : 11b Configured Channel : auto(3)
11、 Configured Power (dBm) : 14 Preamble Type : short Radio Policy : testrp Service Template : 1 (SSID: market_department) Admin State : UP Physical State : UP Operational Rates (Mbps): 1 : mandatory 2 : mandatory 5.5 : supported 11 : supported Radar detected Channels : None -2. 从FTP Server上获取最新版本在AC上,
12、使用FTP Client的功能,登陆FTP Server后,使用get命令,把需要最新AC和AP版本(B05D005),例如wx5002.bin 和wx2100.bin,都下载到AC的Flash中。这时需要注意,不能更改AP的启动文件名称。dir Directory of flash:/ 1 -rw- 5055 Jun 12 2007 09:10:17 config.cfg 2 -rw- 1879880 Jul 25 2007 15:27:34 wa2100.bin 3 -rw- 6864272 Jun 04 2007 13:29:42 wx5002.bin 6899662 KB total
13、(16499 KB free) 3. 保存配置,并重新启动AC保存当前配置,设置最新版本的wx5002.bin为默认启动文件,然后重新启动AC。boot-loader file wx5002_.bin main This command will set boot file, Continue? Y/N:y The specified file will be used as the main boot file at the next reboot! save config.cfg The current configuration will be saved to flash:/confi
14、g.cfg. Continue? Y/N:y flash:/config.cfg exists, overwrite? Y/N:y Now saving current configuration to the device. Saving configuration flash:/config.cfg. Please wait. . Configuration is saved to flash successfully. startup saved-configuration config.cfg Please wait . Done! reboot Start to check conf
15、iguration with next startup configuration file, please wait.Checking is finished! This will reboot device. Continue? Y/N:y4. AP将自动从AC上面获取最新版本这时,AP将通过CAPWAP隧道自动获取最新版本,并自动重启,使其生效。用命令display version查看AC的版本信息,已经显示为B05D005。大约2分钟左右,可以看到AP已经成功重新连接,并且版本已经更新为最新版本。_ versionH3C Comware Platform SoftwareComware
16、 Software, Version 5.00, Release 1103Comware Platform Software Version COMWAREV500R002B35D005H3C WX5002-128 Software Version V100R001B05D005Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.Compiled Jul 24 2007 13:45:37, RELEASE SOFTWAREH3C WX5002-128 uptime is 0 week, 3 days,
17、 18 hours, 0 minute CPU type: BCM MIPS 1250 700MHz 1024M bytes DDR SDRAM Memory 32M bytes Flash Memory Pcb Version: A Logic Version: 1.0 Basic BootROM Version: 1.13 Extend BootROM Version: 1.14 SLOT 1CON (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1GE1/0/1 (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1GE1/
18、0/2 (Hardware)A, (Driver)1.0, (Cpld)1.0 SLOT 1M-E1/0/1 (Hardware)A, (Driver)1.0, (Cpld)1.0 display wlan ap all verbose Total Number of APs configured: 1 Total Number of APs connected : 1 AP Profile: testap - APID : 1 AP Name : testap State : Run Up Time(hh:mm:ss) : 00:00:27 Model : WA2100 Serial-ID
19、: x028652 IP Address : 202.1.1.2 H/W Version : Ver.B S/W Version : V100R001B05D005 Boot-Rom Version : 1.08 Description : -NA- Echo Interval(s) : 10 Statistics report Interval(s) : 600 Cir(Kbps) : -NA- Cbs(Bytes) : -NA- Jumboframe Threshold : Disable Configuration Failure Count : -NA- Last Failure Re
20、ason : -NA- Last Reboot Reason : Tunnel Initiated - AP Mode : Split Maximum Number of Radios : 1 Current Number of Radios : 1 Client Keep-alive Interval : Disable Client Idle Interval(s) : 3600 Broadcast-probe Reply Status : Enable Radio 1: Basic BSSID : 000f-e255-54f0 Current BSS Count : 2 Running
21、Clients Count : 0 Wireless Mode : 11b Configured Channel : auto(3) Configured Power (dBm) : 14 Preamble Type : short Radio Policy : testrp Service Template : 1 (SSID: market_department) Admin State : UP Physical State : UP Operational Rates (Mbps): 1 : mandatory 2 : mandatory 5.5 : supported 11 : su
22、pported Radar detected Channels : None - 4.5 验证结果# 在AC上查看AP状态,确认已经处于连接状态,并且ESS口处于UP状态display wlan ap all Total Number of APs configured: 1 Total Number of APs connected : 1 AP Profiles- AP Name APID State Model Serial-ID- testap 1 Run WA2100 x028652-display brief interfaceThe brief information of in
23、terface(s) under route mode:Interface Link Protocol-link Protocol type Main IPM-E1/0/1 UP DOWN ETHERNET -NULL0 UP UP(spoofing) NULL -Vlan1 UP UP ETHERNET 202.1.1.10The brief information of interface(s) under bridge mode:Interface Link Speed Duplex Link-type PVIDGE1/0/1 UP 1G(a) full(a) trunk 1GE1/0/2 DOWN 1G(a) full(a) access 1WLAN-ESS1 UP - - access 1WLAN-DBSS1:1 UP - - access 15 相关资料5.1 相关协议和标准无5.2 其它相关资料H3C WX系列无线控制产品 用户手册
copyright@ 2008-2023 冰点文库 网站版权所有
经营许可证编号:鄂ICP备19020893号-2